WATTECO - Smart Pilot Wire LoRaWan

The Smart Pilot Wire is a Class C LoRaWAN® actuator that monitors and control up to 6 operating mode for any electric heater as well as any active load (ON/OFF) driven by a relay.

The Class C LoRaWAN® Smart Pilot Wire from nke Watteco is a long range, high performance and high quality wireless actuator having two specific operating mode:

- Smart pilot wire actuator to monitor and control electric heaters
- Switched relay to monitor and control any devices connected to the relay (street lights, residential lights, pumps, fans, valves, motors, generators, …)

When operating as a Smart Pilot Wire, the actuator control up to 6 heating modes:
- Comfort: track, monitor and report the temperature set point of the heater.
- Eco: temperature set and track 4°C below the temperature set point of the heater
- Anti-freeze: maintain room temperature at +5°C
- Stop: no heating
- Comfort – 1: Temperature set and track 1°C below the temperature set point of the heater
- Comfort – 2: Temperature set and track 2°C below the temperature set point of the heater

The Smart Pilot Wire status can be locally stored, concatenated and compressed. This unique batch mechanism significantly reduce the amount of data transmission when reporting the status history of the Smart Pilot Wire output .

FEATURES:

• Electric heater and water heater remote management
• Active load control (ON/OFF) of any devices driven by a relay
• Easy to use and deploy
• Active load monitoring and control
• Data compression for batch status report
• Class II protection

TECHNICAL SPECIFICATIONS :

• RADIO FREQUENCY
  • Frequency (MHz) EU: 863-870
  • Transmitted power (dBm): +14
  • Sensitivity (dBm): -140
• FIRMWARE
  • Protocol: LoRaWAN®, Class C
  • Transmission cycles 10mn, 1h, 12h or defined by network
  • Activation method: Activation by Personalization (ABP) or Over-The-Air Activation (OTAA)
  • Data encryption: AES128 
• ELECTRIC HEATER APPLICATION
  • Comfort: Track the temperature set point of the heater
  • Eco: Temperature set and track 4°C below the temperature set point of the heater
  • AntiFreeze: Maintain room temperature at +5°C
  • Stop: No heating
  • Comfort -1: Temperature set and track 1°C below the temperature set point of the heater
  • Comfort -2: Temperature set and track 2°C below the temperature set point of the heater
• SWITCHED RELAY CONTROL
  • ON: Switch ON
  • OFF: Switch OFF
• POWER
  • Power supply (VAC): 230
• INTERFACE
  • LED Indicator: 3 LEDs for Configuration, Network pairing & Activity on inputs
  • Magnetic Switch: Reset, ON/OFF
• MECHANICAL FEATURES
  • Dimension (mm): 76 x 41 x 17
  • Operating temperature (°C): -20 / +50