SCHNEIDER ELECTRIC - SpaceLogic KNX Actuator 8s Extension

The SpaceLogic KNX Switch / Shutter Extension is an actuator that expands the channels of a SpaceLogic KNX switch / shutter and the channels of a SpaceLogic KNX universal dimming master. The extension can switch a maximum of 8 loads (such as lamps) or control a maximum of 4 shutter motors with end switches. The distribution of functions to the channels can be freely selected and depends on your needs.

All connected loads can be controlled manually using the buttons on the master, but this function can also be deactivated via the ETS.

Device status, such as channel status, readiness in operation or manual operation enabled, is indicated by several LEDs on the master device.

The master fully controls the extensions, their power supply and communication to the bus. You can even program an extension in the existing ETS application of the master. And since an extension has neither a bus coupling nor its own individual address, conventional KNX commissioning is not necessary for an extension.

FEATURES:

• General and extended functions
  • Central function
  • Parameters of extension types
  • Scenario and feedback settings
  • Energy saving
  • Equipment safety
  • Equipment condition
  • Manual operation
  • Firmware update PIN code
• Switch actuator functions
  • Operation as normally closed / normally open contact
  • Programmable behavior for downloading
  • Timing functions for each channel
  • Skylight lighting function with / without manual OFF function
  • Stop warning for staircase lighting function
  • Scenarios
  • Central function
  • Lock function
  • Logical operation or priority management
  • Status feedback function for each channel
• Shutter actuator functions
  • Duration
  • Period of inactivity
  • Step interval
  • Lock function
  • Limits of range of motion
  • Weather Alert
  • 8-bit positioning for height and blades
  • Scenarios
  • Status and feedback function

TECHNICAL SPECIFICATIONS :

• Supply voltage: via link interface
• Insulation: protective separation between the bus and the mains voltage
• Power dissipation: <8 W
• KNX support: TP1-256
• Switching contacts: 8x NO contacts, μ contact
• Nominal voltage: 250 V AC, 50-60 Hz
• Nominal current: 16 A AC-1, IEC 60947-4-1 10 A, IEC 60669-2-5
• Nominal power :
  • Incandescent lamp: 2300 W
  • Halogen lamp: 2300 W
  • LED lamp: 200 W
  • Motor: 1000 VA
  • Electronic transformer: 1500 VA
  • Ferro-magnetic transformer: 1200 VA
• Switching frequency: max. 10 per minute at rated load
• Relay data:
  • Inrush current: max. 800 A / 200 μs, max. 165 A / 20 ms
  • Mechanical resistance:> 1x10 6 operations
• Fuses: miniature circuit breaker max. 16 A
• Environment :
  • Operating temperature: -5 ° C ... +55 ° C
  • Max humidity : 93%, non-condensing
  • Installation height: up to 2000 m above sea level
• Fire and heat resistance: glow wire test according to standard IEC 60695
• Connection terminals
  • KNX: bus connection terminal
  • Mains: 2 screw terminals 8 channels
• Device size: 4 modules = 72 mm approx.