RFXCOM - Teleinfo "historique" & Linky for RFXtrx433XL

This Teleinfo option PCB is only available for the RFXtrx433XL batch 4918 and later (xx19)
The batch number is on the label on the backside of the enclosure.

This Teleinfo option is pressed in the RFXtrx PCB and does not need a soldering tool. It is delivered with a cable of 1.5m which can be connected to the French power meter.

To install the Teleinfo option PCB on the RFXtrx433XL version 5.1:

1. Open the enclosure by removing the 4 screws.
2. Press the 5 pins of the P1 PCB into the RFXtrx433XL PCB RFXtrx V5.1.
   Use a wrench to push the connector into the PCB until the black part of the Press-Fit connector is on the RFXtrx PCB.
3. Cut a few plastics from the upper side (only the raised edge) of the enclosure for the cable, using a Stanley knife. 
4. Cut also at the same position a few plastics from the raised edge of the bottom part.
5. Close the enclosure. First turn the screw counter clockwise until you hear/feel a soft click, now turn the screw clockwise and fix the screw (not too tight)

• Eedomus : Téléinformation avec l'interface RFXCOM